Most Oakland garage door repairs we run cost between $130 and $400, parts and labor included. A single torsion spring is $189 to $349 installed. Cables are $160 to $290 a pair. Opener repairs sit between $140 and $340. Diagnosis is $45 to $95 and comes off the bill when we do the work. Call (415) 494-4774 for the exact figure on your door.
| Job | Oakland price |
|---|---|
| Diagnostic visit, credited toward the repair | $45–$95 |
| Single torsion spring, installed | $189–$349 |
| Both torsion springs replaced together | $320–$560 |
| Extension spring pair with safety cables | $220–$420 |
| Lift cable pair, replaced and tensioned | $160–$290 |
| Cables plus drum reset and balance check | $190–$360 |
| Door re-seated, track trued, cause corrected | $165–$390 |
| Opener gear and sprocket | $140–$280 |
| Opener logic board or receiver | $190–$340 |
| Roller set, sealed-bearing nylon | $130–$260 |
| 20-point lube and tune | $95–$165 |
| Controls work: remote, keypad or wiring | $60–$220 |
| Single steel section, supplied and installed | $250–$800 |
| New single-car door, installed | $1,200–$2,800 |
Prices are parts plus labor. You get the exact figure in writing before we start. Alfonso Garage Door is a licensed and insured California contractor.
Apartment and condo garages take coordination as well as parts. Around Lake Merritt, Adams Point and downtown, a lot of the doors we fix are shared: a secured entry gate or a common garage serving a whole building. Those jobs price the same per part, and what changes is the visit itself: we schedule with the manager, badge in, and test every remote on the way out. If you are the one resident whose remote stopped working, that is usually a $40 to $85 programming visit, not a door repair.
Soft-story buildings put the door inside a structural wall. Oakland has been running a soft-story retrofit program for years, and when a garage opening has been strengthened with a steel frame, the door has to be refitted to the new dimensions. We measure the finished opening rather than assuming the old door size, and where a retrofit is planned but not done, we say so before you spend money on a door the contractor will pull out.
The flats run older steel doors that bend before they break. East of the lake and down through Fruitvale and Elmhurst, the common door is a 40-year-old one-piece or early sectional steel door. Those rarely fail all at once. They drag, then bind, then fold a track edge. Caught at the drag stage it is a $130 to $260 realignment; at the folded stage it is track sections at $220 to $380 a side.
“On a shared Oakland garage I test every remote before I leave. One resident locked out at midnight means the whole building hears about it.”
The same three tests as everywhere: past 20 years old, third paid repair inside two years, or a quote over half the price of a new door installed, and replacement wins the decade. On a one-piece steel door from the 1980s, the right call is usually a new sectional at $1,200 to $2,800 installed, because the old door has no parts market left. Both numbers go on paper in the same visit. The full list is on the San Francisco cost guide.
Serving Oakland same-day, 24 hours a day, every day.
$189 to $349 for a single torsion spring installed, $320 to $560 for the pair. Wide doors in the hills usually carry two springs.
Yes. We coordinate with the building manager, and we test every resident remote before leaving. Programming a single remote is $40 to $85.
It changes the measurements. The door gets fitted to the finished steel-framed opening, and we measure that opening rather than trusting the original door size. The part prices themselves are unchanged.
Yes, straight across the bridge. Most Oakland calls get a same-day slot, and the diagnostic is $45 to $95, credited toward the repair.
$1,200 to $2,800 installed for a new single sectional. One-piece doors from the 1980s have no parts market, so replacement is usually the better spend.
Every page below carries its own cost breakdown, or skip the reading and call (415) 494-4774 for an exact quote today.
